Numerical Simulation and Optimization of Airflow Distribution Characteristics in the Air Distribution Chamber of a Needle-type Forage Dryer
Abstract
To address uneven air supply among multiple needle tubes during the drying of high-density forage bales, this study investigated the airflow characteristics and structural optimization of the upper and lower air distribution chambers of a needle-type forage dryer. A three-dimensional CFD model was established, and airflow performance was evaluated using the velocity non-uniformity coefficient M and the inlet-to-outlet total pressure drop Δp. Response surface methodology was used to optimize the key structural parameters. For the upper chamber, installation of a T-shaped baffle and optimization of the cavity height Hc, diffuser angle α, and top-plate opening area ratio Ra yielded an optimal combination of Hc = 133.29 mm, α = 12.51°, and Ra = 1.12, reducing M from 11.2264% to 3.3886%. For the lower chamber, a strip-perforated airflow equalizing plate with Hb = 74.82 mm, D = 23.79 mm, and W = 25.03 mm reduced M from 9.8772% to 1.5484%, with Δp of approximately 130 Pa. Mesh-refinement and turbulence-model sensitivity analyses supported the robustness of the numerical predictions. Repeated outlet-velocity measurements yielded mean absolute relative errors of 3.09%–4.58%. Smoke visualization and grayscale analysis further indicated that the optimized structures enhanced airflow diffusion and redistribution. The results provide guidance for air distribution chamber design in needle-type forage dryers.