Skip to content
Conference Open access

Development of a 3D Electronic Detector Array for Radiotherapy Quality Assurance

Sep 2026 · Journal of Physics, Conference Series · Vol 3327 · 0 citations · 5 references
Physics

TL;DR

Results indicate that the detector can provide reliable and reproducible data and demonstrate the applicability of active-matrix technology to experimental 3D dosimetry in radiotherapy.

Abstract

A three-dimensional electronic detector array proof-of-principle prototype based on active-matrix technology was developed for radiotherapy dosimetry. The system consists of a 30×30×15 cm3 PMMA phantom with 2645 embedded detector elements distributed in five active matrices at five depths. Percent depth-dose (PDD) and profile measurements for a 6 MV photon beam from different radiotherapy linacs were acquired and compared to GEANT 4 Monte Carlo simulations. Deviations were < 1% (MCDetector - modelled detector) and < 3% (MCPMMA - PMMA medium). Measurement versus simulation average difference was 0.5% (MCDetector) and 1.3% (MCPMMA) within the irradiated field. Reproducibility across measurements was 0.5%. These results indicate that the detector can provide reliable and reproducible data and demonstrate the applicability of active-matrix technology to experimental 3D dosimetry in radiotherapy.

Read PDF

Similar papers

Conference Open access Sep 2026

Dosimetric assessment of radiation fields up to 5 × 5 cm2 and architectural optimization of a diode-based 3D Detector for radiotherapy

An initial 3D electronic detector array prototype for radiotherapy, consisting of 2645 diodes (8.0 mm pitch), was modelled with Geant4 and MCNP6.2 Monte Carlo codes to simulate irradiations of 2×2, 3×3, 4×4, and 5×5 cm2 field sizes with a 6 MV photon beam. Comparisons with Treatment Planning Software (TPS) data reveale...

R. Ocampo, D. Roa, Enzo Aucca et al. · 0 citations
Open access Oct 2026

easyPET.3D measurement of positron emitter maps in proton-irradiated PMMA phantoms

Accurate range verification is a critical component of proton therapy, ensuring that the high dose gradients characteristic of Bragg peaks are delivered precisely to the target volume. This work presents the first experimental evaluation of the easyPET.3D, a compact and cost-effective preclinical positron emission tomo...

A. C. M. Magalhães, P. Correia, M. Grossmann et al. · 0 citations
Sep 2026

Study of three-dimensional dose distribution measurement of ultra-high dose rate electron beam

Objective. FLASH radiotherapy which employs an ultra-high dose rate (UHDR) ( >40 Gy s −1), effectively protects normal tissues and organs while maintaining robust tumor control. However, it also presents serious challenges for quality assurance (QA). Currently, dosimeters face various limitations under FLASH radiothera...

Wei Zhang, Chang Cheng, Rong-Hu Mao et al. · 0 citations
Sep 2026

Clinical commissioning of a commercial brass GRID collimator for spatially fractionated radiotherapy.

Despite its substantial weight and limited maximum field size, GRID-based SFRT offers straightforward treatment planning, efficient dose delivery, and the potential to enhance tumor control through its characteristic peak-to-valley dose distribution.

R. Yaparpalvi, D. Mynampati, M. Garg et al. · 0 citations
Open access Sep 2026

A Comparative Analysis of the Photon Beam Percentage Depth Dose in an Elekta Linear Accelerator at a Comprehensive Cancer Center

This study aims to verify the photon beam energy characteristics of an Elekta Synergy Platform LINAC at Kathmandu Cancer Center, Tathali Nala road by comparing measured PDD data with established British Journal of Radiology (BJR) Supplement 25 and other published literature. PDD measurements were performed for photon e...

Raja Prajapat, Junaid Abdul Salam, A. Adhikari et al. · 0 citations
Conference Open access Sep 2026

CT-Based Dose Measurements with an Enhanced Bone-Mimicking 3D Dosimeter

Advanced 3D dosimetry materials are essential for high-resolution measurement of dose distributions in radiotherapy. This study investigates a bone-mimicking 3D dosimeter, developed as part of a broader project on multiphase dosimeters replicating different human tissues. The dosimeter formulation was modified with mag...

M. Kozicki, M. Jaszczak-Kuligowska, P. Maras · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.