Oct 2026· ACS Applied Energy Materials· 0 citations· 50 references
Abstract
Surface coating with a lithium-ion conductor is an effective strategy for improving the electrochemical performance of positive electrode materials for lithium-ion batteries. However, preparing a uniform coating by a simple, cost-effective, and solvent-free process remains challenging. Here, we show that simply mixing Ni-rich LiNi0.85Mn0.10Co0.05O2 (NMC) positive electrode material with Al2O3 nanoparticles (NPs) causes the residual alkali species on the NMC surface to spontaneously react with the Al2O3 NPs, forming a Li–Al oxide layer and thereby improving the electrochemical performance of Ni-rich NMC. Full-cell tests at 45 °C showed that 0.25 wt % Al2O3 NPs markedly improved capacity retention, particularly at high rates. pH titration and hard X-ray photoelectron spectroscopy revealed that residual LiOH reacted with Al2O3 NPs to form Li–Al oxides on the NMC surface before cycling. This indicates a spontaneous reaction between Al2O3 NPs and residual LiOH during dry mixing. Energy-dispersive X-ray spectroscopy mapping further revealed that a thin Al-rich layer a few nanometers thick was formed even on surface regions distant from the Al2O3 NPs, suggesting that the Al2O3 NPs reacted with LiOH distributed across the entire NMC surface, thereby forming a nanoscale coating layer. Postmortem scanning transmission electron microscopy coupled with electron energy-loss spectroscopy analysis confirmed a reduced NiO-like rock-salt layer after cycling, indicating that the self-formed Li–Al oxide layer suppresses surface degradation. This solvent-free coating approach offers a simple, cost-effective, and environmentally friendly route for improving the electrochemical performance of Ni-rich NMC.
Maintaining a stable interface between sulfide solid-state electrolytes and layered oxide cathodes remains a major challenge limiting the performance of all-solid-state batteries. Atomic layer deposition (ALD) of lithium niobate (LNO) on layered oxide cathodes is widely used to stabilize these interfaces, yet the ear...
Jaka Šivavec, L. Lapeyre, D. Casari et al.· ACS Energy Letters· 0 citations
LiFePO4 cathodes have gained much attention for Li-ion batteries due to their superior electrochemical and economic features. However, their practical applications are limited by poor electronic conductivity, sluggish lithium-ion diffusion, and unstable cathode/electrolyte interfaces. Conventional approaches require se...
Mohammed A. M. M. al-Samet, Engin Burgaz· ACS Applied Materials and In...· 0 citations
Applying a surface coating is among the most promising and fundamental approaches in improving the performance of existing electrode materials. This work examines four ultrathin coating materials (Al2O3, alucone, TiO2, and titanicone) applied on single-crystal LiNi0.83Mn0.06Co0.11O2 electrode sheets by atomic layer d...
Tyler Or, Dan Luo, Karthikeyan Kaliyappan et al.· Journal of Physical Chemistr...· 0 citations
Lithium-ion batteries (LIBs) require stable high-voltage cathode materials to meet escalating energy storage demands. LiNi0.5Mn1.5O4 (LNMO) offers high energy density while employing earth-abundant manganese but suffers from degradation due to manganese dissolution and electrolyte decomposition at elevated voltages. Th...
Nashmiya Basheer, Ingmar Pietsch, Max Stevenson et al.· Small· 0 citations