Investigating Fracture Behavior of Lattice Structures Using the XFEM and Equivalent Solid Material Model Techniques
Abstract
This study aims to numerically investigate the mode I, II, and III fracture behaviors of additively manufactured degradable, bioplastic polylactic acid (PLA) lattice specimens. Numerical simulations were performed using the eXtended Finite Element Method (XFEM) based on the extracted PLA's mechanical and fracture material properties. The maximum principal stress and fracture energy power‐law criteria were utilized to simulate damage initiation and evolution in three‐dimensional (3D) numerical analyses. To consider the effects of build orientation, the transversely isotropic elasticity model (TIEM) was implemented. To facilitate the XFEM analyses, the equivalent solid material model (ESMM) technique was also utilized. The experimental load‐displacement responses of single‐edge notched bending specimens under the symmetric and asymmetric four‐point bending and mode III transverse shear cracked plate tests were conducted for comparison with the XFEM analyses in mode I, II, and III fracture, respectively. A common calibration factor, as well as the simultaneous utilization of the TIEM model, as well as the XFEM and ESMM techniques, reflected numerical results of acceptable accuracy compared to the experimental results; 5.3% (3.4%), 4.4% (5.8%), and 9.6% (5.4%) differences for the stiffness (peak load) of mode I, II, and III specimens, respectively.