Interface Engineering and Defect Tolerance in RbSnBr₃ Perovskite Solar Cells: A Numerical Analysis of HTL Impact
Abstract
This work presents a systematic SCAPS-1D investigation of the influence of five hole transport layers (HTLs), namely CuSCN, Cu2O, P3HT, PTAA, and PEDOT:PSS, on the interface energetics, charge transport, defect tolerance, and photovoltaic performance of lead-free RbSnBr₃ perovskite solar cells employing the FTO/SnS₂/ RbSnBr₃/ HTL/ Au device architecture. To isolate the intrinsic influence of HTL properties, all device parameters, interfaces, and operating conditions were kept identical except for the HTL material. Unlike conventional HTL-screening studies that primarily compare photovoltaic performance, the present work integrates analyses of energy-band alignment, current–voltage (J–V), quantum efficiency (QE), capacitance–voltage (C–V), conductance–voltage (G–V), density of states, carrier mobility, contact engineering, bulk and interface defects, and temperature-dependent characteristics to establish the physical relationship between HTL properties and device operation. PEDOT: PSS and P3HT exhibited comparable simulated photovoltaic performances, achieving power conversion efficiencies (PCEs) of 22.87% and 22.86%, respectively. Their favorable performance is attributed to suitable energy-band alignment, efficient hole extraction, balanced carrier transport, and reduced recombination under the investigated simulation conditions. The integrated analyses demonstrate that HTL selection governs device behavior primarily through interface-controlled electrical processes, while the sensitivity to the assumed defect conditions further influences carrier recombination and overall device performance. These findings provide a comprehensive physical understanding of HTL-controlled interface engineering in lead-free RbSnBr₃ perovskite solar cells and offer theoretical guidance for their future experimental optimization.