Research and preparation of 1–3 type flexible piezoelectric composite materials
Abstract
Piezoelectric composites have emerged as a viable alternative to monolithic piezoelectric ceramics, owing to their low density, favorable acoustic impedance matching, high sensitivity, and wide bandwidth. However, conventional epoxy-based composites frequently exhibit brittleness and deformation failure under long-term high-frequency vibration, and they are unable to meet the detection requirements for curved-surface applications. The present study addresses these limitations by developing a 1–3 type flexible piezoelectric composite. A theoretical analysis and COMSOL finite-element simulations were performed to investigate the electromechanical behavior of the composite. These revealed a nonlinear relationship between ceramic phase thickness and resonant frequency. The analysis also determined design parameters for high-frequency operation. It was predicted by simulations that a resonant frequency of 330 kHz would be observed, with synchronized thickness vibration modes in the piezoelectric phase. A novel fabrication process involving separate preparation and assembly of the piezoelectric and flexible polymer phases was proposed. Five independently fabricated specimens exhibited a mean resonance frequency of 332.74 ± 0.79 kHz, corresponding to an average deviation of only 2.74 kHz from the simulated value of 330 kHz. The 1–3 type flexible piezoelectric composite demonstrates a high effective electromechanical coupling coefficient of 0.70 and a broad frequency bandwidth ΔF of 134.38 kHz, indicating improved thickness-mode electromechanical performance compared with the investigated monolithic lead zirconate titanate sample. The material exhibits the same high electrical performance as rigid composites, while also demonstrating superior flexibility in bending and twisting. This suggests that it has great potential for use in curved-surface ultrasonic inspection and flexible ultrasonic skin.