Experimental investigation of the combustion of natural gas/hydrogen mixtures in a laboratory-scale combustor
Abstract
Global warming caused by greenhouse gas emissions requires major changes in the energy sector to mitigate the rise in atmospheric temperature. One of the most important strategies to address this challenge is the replacement of fossil fuels with cleaner sources, and hydrogen is widely recognised as a promising alternative. The combustion of natural gas/hydrogen mixtures was experimentally studied using a novel laboratory-scale combustor featuring a non-conventional air staged configuration. Secondary air is injected counter-current to the fuel jet delivered through a swirl burner operating at constant thermal power. This design aims to improve mixing and reduce NOx emissions. Experimental studies on hydrogen-enriched combustion with counterflow secondary-air injection have received little attention. The effects of fuel composition (0%−100% vol. H2 in the mixture), excess air coefficient (λ = 1.3−1.7) and primary air percentage (α=50%−100%) on the temperature distribution and flue gas composition were investigated. At constant excess air and primary air levels, an increase in the hydrogen fraction in the fuel has a marginal influence on the temperature up to 80% H2 but a greater impact when pure hydrogen is burnt. At λ=1.3, high CO emissions were observed when secondary air was introduced, suggesting incomplete combustion. However, CO levels decreased with increasing excess air, reduced secondary air injection, or hydrogen content above 20%. NOx emissions at λ=1.3 increased with hydrogen content, peaking when pure hydrogen was burned. Moreover, they decreased slightly as α increased from 50 to 66.7% and then rose again for α=100%. At higher excess air coefficients, NOx emissions remained relatively stable up to 80% H2 but increased for pure hydrogen, although remaining below 90 ppm. While secondary air injection effectively reduced NOx emissions, it also elevated CO levels, making it beneficial only when CO emissions are kept within acceptable ranges.