Skip to content
Open access

Finite element evaluation of the structural and thermal integrity of a traffic cone made from densified low-density polyethylene and expanded polystyrene

Sep 2026 · International Journal of Advanced Technology and Engineering Exploration · 0 citations

Abstract

The growing volume of plastic waste has prompted research into densified plastic as an alternative construction material. Its mechanical and physical properties should be evaluated to determine its suitability for specific applications. In this study, low-density polyethylene (LDPE) and expanded polystyrene (EPS) were collected, densified, and tested in accordance with relevant standards. The selected mixture was then used to fabricate traffic cones. Finite element method (FEM) simulations predicted their compressive behavior under idealized conditions, and laboratory tests compared the predicted and observed results. The three laboratory specimens had yield strengths ranging from 13.67 to 18.56 MPa. The FEM simulation predicted a yield strength of 17.92 MPa and a maximum deformation of 3.52 mm in the upper region of the cone. Laboratory failure was also observed in the upper region, approximately 0.35-0.40 m from the top. Thermal stress simulation indicated that the prototype was likely to soften at 200 °C, with the upper region most susceptible to deformation. The densified plastic traffic cones showed consistent mechanical performance across the tested specimens. The agreement between the simulated and experimental results suggests that FEM can help predict their behavior and guide improvements to the material and fabrication process.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.