Skip to content
Open access

Adaptive Sliding Mode Position Control and Impedance Force Feedback for Bilateral Teleoperation

Nov 2026 · Automation · Vol 7, pp. 176 · 0 citations · 25 references

TL;DR

The results demonstrate the robustness of the proposed role-specific architecture under the considered uncertainty and communication conditions, while higher-DOF and experimental validation remain subjects for future work.

Abstract

This paper investigates bilateral teleoperation under time-varying communication delays and dynamic uncertainties. A role-specific asymmetric master–slave control architecture is proposed, in which impedance control is assigned to the master side for interaction-dynamics shaping and force feedback, while adaptive sliding mode control (SMC) is employed at the slave side for robust position tracking. A radial basis function neural network (RBFNN) is integrated into the slave-side SMC to compensate for uncertain nonlinear dynamics without requiring exact identification of the slave model. The adaptive laws are derived using Lyapunov stability analysis, and the approximation and adaptive estimation errors are explicitly considered. Under the stated boundedness conditions, the adaptive estimation errors and sliding variable remain bounded, and the slave position tracking error asymptotically converges to zero. The simulation results show that the proposed method substantially reduces the sensitivity of tracking performance to model uncertainty, with the IAPE remaining between 0.0031 and 0.0035 under 20–40% mismatch, compared with 0.2029–0.4057 for conventional SMC. Additional simulations with time-varying communication delays demonstrate bounded tracking performance, although delay-induced phase shifts and transient oscillations remain. The results demonstrate the robustness of the proposed role-specific architecture under the considered uncertainty and communication conditions, while higher-DOF and experimental validation remain subjects for future work.

Read PDF

Similar papers

Open access Nov 2026

Adaptive Nonsingular Terminal Sliding Mode Control for Electro-Hydraulic Servo Systems Based on RBF Neural Network and Nonlinear Tracking Differentiator

To address the challenges of non-smooth reference force commands, uncertain nonlinear dynamics, and external load disturbances in electro-hydraulic servo systems (EHSSs), this study proposes an adaptive nonsingular terminal sliding mode control (ANTSMC) method combined with a nonlinear tracking differentiator (NTD) and...

Ye-Chun Ma, Jing Yang, Kai-Lei Liu et al. · 0 citations
Open access Nov 2026

Robust Position Tracking Control of Bearing Universal Joint Transmission Systems Under Multiple Disturbances

This paper addresses the position tracking control problem for bearing universal joint (BUJ) transmission systems subject to multiple disturbances, including model uncertainties, unmodelled friction, external loads and measurement noise. The main contribution of this work is a robust adaptive control framework that i...

Xiang-Yang Cao, Man-Shu Zhan, Hang-Yu Dan · 0 citations
2026

NN-Based Fuzzy Adaptive Control for UAVs Using Cascaded Architecture Under Unmatched Uncertainties and Interference

This paper proposes a fuzzy-logic-system-based adaptive control (FLSAC) strategy for position and attitude tracking of a quadrotor subject to lumped nonlinear uncertainties and bounded external disturbances. The controller adopts a cascaded structure, in which the outer position loop and inner attitude loop employ chan...

Qing-Mei Cao, Yang-Zhe Xie, Yong-Hong Tan et al. · 0 citations
Conference Open access Sep 2026

Predictive Performance-Based Adaptive PI Control for PMSM Drives

To address the degradation of speed-loop control performance caused by external disturbances and parameter uncertainties, this paper proposes a learning-enhanced predictive PI auto-tuning method for PMSM drives. A discrete-time speed-loop model and a finite-horizon cost function are constructed to balance tracking accu...

Jun Gu, Shi-Tao Song, Zhe-Xi Xu et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.