Skip to content
Open access

Development and Experimental Evaluation of a Compact Acoustic Emission System for Industrial Monitoring

2026 · IEEE Transactions on Instrumentation and Measurement · Vol 75, pp. 9705009-9705009 · 0 citations · 44 references

Abstract

Acoustic emission (AE) sensing is widely used in industrial monitoring due to its sensitivity to transient mechanical phenomena. Conventional AE systems, however, usually depend on wired sensors, external signal conditioning, and high-speed acquisition hardware, which limits their use in distributed and noise-prone environments. This article presents the development and experimental evaluation of a compact AE measurement system for industrial monitoring. The proposed system integrates a piezoelectric sensing element, analog conditioning, high-speed acquisition, local storage, and wireless communication into a single portable architecture. The system was experimentally evaluated through electrical characterization, standardized pencil lead break (PLB) tests, industrial noise measurements, and micro-milling experiments. The measured spectral response exhibited most of its effective energy concentrated between approximately 40 and 150 kHz and achieved system-level integrated energy levels more than 10 dB higher than those of commercial reference systems within the analyzed frequency band. Under industrial noise conditions, the signal-to-noise ratio (SNR) remained close to 29 dB, whereas the commercial sensors exhibited noticeable degradation, indicating reduced susceptibility to environmental interference. In micro-milling experiments, root mean square (rms)-based analysis enabled reliable identification of the tool–workpiece interaction interval, with stable SNR values around 21 dB and relative errors below 2.1 % with respect to the nominal toolpath length. Acoustic mapping synchronized with tool motion also enabled spatial identification of the cutting edges of a $500~\mu $ m diameter tool. These results demonstrate that the proposed system provides reliable acquisition of low-amplitude AE signals and supports process-level analysis in industrial monitoring environments.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.