Skip to content

CFD Modeling of Dual-Fuel Ammonia Combustion in a High-Speed Diesel Engine: Effects of Equivalence Ratio and Wall Temperature

Sep 2026 · ASME 2026 DRIVN Global Transportation and Power Systems Summit · 0 citations

Abstract

Ammonia has been identified as a promising alternative fuel for maritime transportation. However, several challenges remain due to its low cetane number, low flame speed, and high emissions formation. This study presents a detailed computational fluid dynamics (CFD) investigation of dual-fuel ammonia combustion with pilot diesel injection in a single-cylinder high-speed diesel engine. The Reynolds-averaged Navier Stokes (RANS) framework with the renormalization group (RNG) 𝑘-𝜖 model is used to model flow turbulence. Detailed chemistry is employed to capture the pilot ignition and main combustion processes, coupled with a new four-component diesel surrogate and a new chemical reaction mechanism for ammonia/diesel dual fuel, both developed as part of this study. The model accuracy is evaluated against experimental data at global air-fuel equivalence ratios (λ) of 1.0 to 1.6 with greater than 90% ammonia energy ratio (AER). Overall, CFD shows good agreement with the measured in-cylinder pressure and apparent heat release rate (AHRR) for all λ conditions. For emissions, NO is well predicted, while N2O and unburnt NH3 are over- and under-predicted, respectively. Two extreme cases corresponding to λ = 1.6 (leanest condition) and λ = 1.0 (richest condition) are analyzed in detail to understand the effect of λ on the ignition, combustion, and emissions formation processes. For λ = 1.6, the ignition process consists of a distinct initial peak in AHRR associated with diesel pilot combustion, followed by a valley and second rise in AHRR signifying the onset of main ammonia combustion. In contrast, for λ = 1.0, AHRR increases monotonically during ignition and more rapidly compared to λ = 1.6, suggesting a stronger coupling between diesel and ammonia combustion. Finally, a sensitivity analysis is conducted to understand the impact of wall temperature on CFD predictions of the combustion and emissions formation processes. Results show that while both combustion and emissions characteristics are strongly affected by the wall temperature at λ = 1.6, the λ = 1.0 results are not sensitive to the wall temperature.

View source

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.