High fracturing pressure is a critical challenge in stimulating ultra‑deep carbonate reservoirs. Acid pretreatment of the near‑wellbore zone can reduce rock strength and fracture pressure, yet existing models fail to integrate acid‑rock reactions, geological conditions, and operational parameters, leading to inaccurate predictions and treatment risks. Using core data from Well P1, we conducted laboratory tests to quantify damage evolution under drilling‑fluid and acid exposure, and developed a damage constitutive model for different fluid types and acidizing durations. A multi‑field coupled numerical model was then built, coupling wellbore-reservoir flow, chemical reactions, in‑situ stress, and elastoplastic damage, with porosity and permeability evolution under deep high‑temperature and high‑pressure conditions. For Well P1, direct fracturing required a wellhead pressure of 157 MPa, exceeding the limit. Conventional acid fracturing at 1.5 m3/min still required 126 MPa, near the operational ceiling. We therefore proposed a composite "soaking + acid fracturing" process, with a one‑hour soaking period. Simulations predicted a fracturing pressure of 179 MPa, corresponding to a wellhead pressure of 109 MPa, well within the 126‑MPa rating of the 140‑grade wellhead, greatly improving safety. Field data confirmed that the actual breakdown pressure was 177 MPa, matching the model prediction with an error <3%, a 14% improvement over conventional tensile models. This work provides a validated, experimentally calibrated method for predicting dynamic fracture pressure after acid damage in ultra‑deep carbonates, supporting future stimulation design in similar challenging settings.
Hydraulic fracturing is critical for complex geothermal and deep hydrocarbon reservoirs, such as the Brazilian Pre-salt carbonates. However, conventional fracturing models neglect the thermo-hydro-mechanical coupling process in hot rock formations subjected to cold waterflooding. This work investigates the thermal im...
J. Rueda, C. Mejía, P. Firme et al.· Rock Mechanics and Rock Engi...· 0 citations
Coal reservoirs exhibit strong heterogeneity and complex in situ stress conditions, and the initiation and propagation of hydraulic fractures are jointly controlled by reservoir geology and perforation design. A damage–seepage coupled numerical model was established on the COMSOL Multiphysics platform (Version 6.2) by...
Bao-Lei Xie, Zhi-Wen Xue, Yong-Qiang Ma et al.· Processes· 0 citations
Conventional drilling fluid density design based on the onset of yielding may not adequately balance wellbore stability against the available mud-weight window in deepwater sandstone–mudstone interbeds, where collapse and lost-circulation risks coexist. Using three-pressure profiles, actual mud weights, and operational...
Accurate characterization of the in situ stress field in ultra-deep fractured-vuggy carbonate reservoirs is essential for optimizing hydraulic fracturing design and well trajectory planning. This study presents a numerical investigation of the stress field in the Aiding block of the Tahe Oilfield, a typical ultra-deep...
Acid fracturing is widely applied to enhance production from oil, gas, and geothermal reservoirs in fractured carbonate formations. Because acid preferentially flows along natural fractures, accurate prediction of acid-etched fracture behavior is essential. However, existing acid-etching models fail to account for fr...
Bo Gou, Zi-Hao Liu, Jian-Chun Guo et al.· SPE Journal· 0 citations
In the Shenfu block, deep methane reservoirs from coal seams at depths of 2000-3000 m face challenges such as high water consumption during conventional hydrofracturing, elevated treatment costs for the resulting fluids, and limited effectiveness in modifying the fracture network. CO2 foam fracturing, as a transformati...
Zhan-Jiang Zhao, Tuo Liang, Tian-Shuang Yang et al.· International Conference on...· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.