Skip to content

Performance Study of an Onboard Power Generation System with Liquid Hydrogen Intercooling and Recuperation Based on Aviation Fuel Cells

Oct 2026 · SAE technical paper series · 0 citations · 20 references

Abstract

Electrification in aviation imposes higher requirements for the power density and operational efficiency of onboard power systems. Conventional auxiliary power units currently face bottlenecks in both efficiency and emissions. Hybrid power systems consisting of proton exchange membrane fuel cells and gas turbines are considered a promising solution because they enable cascaded energy utilization. Integrating such hybrid systems with the main turboshaft engine represents an important technical path for improving performance. However, extracting interstage bleed air from the main engine compressor leads to propulsion power loss, and the performance of the fuel cell is significantly influenced by temperature and pressure. Therefore, quantifying the trade-off between the cost of bleed air and the gain in power generation is essential for verifying the feasibility of this technology. This paper proposes a thermodynamic model coupling a main turboshaft engine with a fuel cell and gas turbine subsystem. In this model, a novel thermal management strategy employs liquid hydrogen to cool interstage bleed air. Prior to entering the cathode, the bleed air undergoes cooling via heat exchange, while the high-temperature turbine exhaust stream concurrently preheats the hydrogen before it reaches the anode. Bleed air losses are quantified through a segmented compression work calculation, and the influence of bleed air pressure ratio, current density, and fuel utilization on overall system performance is systematically examined. System net benefit is defined as the net generated power minus the associated propulsion power penalty. The results indicate that, with suitable parameter coordination, a positive net benefit can be realized. Under typical operating conditions, the system attains a net benefit of thirty-two point two kilowatts. The proposed coupling architecture offers a theoretical reference for the design of hydrogen-based hybrid propulsion systems in aviation.

View source

Similar papers

Oct 2026

Performance and Scheme Study of the Hybrid Engine Integrated PEMFC with Jet Engine for Commuter Aircraft

To support aviation decarbonization and improve overall propulsion efficiency, this paper proposes a hybrid propulsion architecture integrating a proton exchange membrane fuel cell (PEMFC) with a turbofan engine. The proposed parallel hybrid configuration achieves efficient energy conversion through the thermodyn...

Meng-Xuan Huang, Zhi-Xing Ji, Jiao Huang et al. · 0 citations
Oct 2026

Closed-Loop Steam-Injected SOFC-GT Propulsion System with Thrust Compensation for High-Altitude Hydrogen UAVs

To address the requirements of high thermal efficiency and strict thermal control for high altitude long endurance unmanned aerial vehicles, as well as the problems of large additional water load and difficult high altitude condensation in traditional steam injected cycle aero engines, this paper proposes a closed...

Qi-Ming Kang, Yi-Ling Shen, Cheng-Jie Li et al. · 0 citations
Open access Oct 2026

Modeling Hydrogen Fuel Cell of High-Speed Passenger Ship by Using Simulink

The maritime industry is under increasing pressure from environmental regulations, and therefore, it is required to provide energy solutions that comply with sustainable practices immediately. The study conducted by the researchers indicates the creation of a hydrogen fuel cell model that is designed specifically for t...

Japhet Augustino · 0 citations
Open access Oct 2026

Influence of exhaust backpressure on the performance of port-fuel-injected large-bore hydrogen engines with different turbocharger configurations

The transition of large-bore internal combustion engines to hydrogen offers a pathway for decarbonizing stationary power generation. However, achieving competitive power densities with port fuel injection requires high charging pressures due to intake air displacement and lean-burn combustion. The combination of high c...

Felina Armbruster, Moritz Lerchner, Andreas Zepf et al. · 0 citations
Open access Sep 2026

Design of a Compact, Lightweight, and Efficient 3kW DC-DC Power Converter for Hydrogen-Propelled Drones

Given the increasing urgency to reduce the carbon footprint and address climate challenges, there is a push for clean energy sources and efficient energy storage methods. In this context, hydrogen emerges as a highly interesting energy vector due to its high gravimetric density and its capacity for sustainable producti...

Javier López Soria, A. Barrado, Víctor Díaz Alías et al. · 0 citations

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.