Skip to content

Design, calibration, and classroom implementation of a low-cost gear apparatus for secondary physics education

Sep 2026 · The Physical Educator · Vol 61 · 0 citations · 23 references
Physics

Abstract

Hands-on apparatus can make rotational mechanics more observable and measurable for secondary students, yet many gear instructional kits are costly, small-scale, or impractical for classroom deployment. This study reports the design and calibration of a low-cost, scalable hands-on gear apparatus for upper secondary physics, enabling students to investigate gear ratio relationships through direct measurement of rotational motion and torque transmission, quantitative comparison between theoretical and experimental values. The apparatus was designed using two-dimensional modelling (Rhinoceros) and fabricated from 3 mm plywood via laser cutting to ensure reproducibility and rapid replacement of parts. The learning set was evaluated with upper secondary students (n = 90) during classroom-based investigations in which experimentally measured outcomes were compared with theoretical predictions derived from gear tooth ratios. Calibration results showed mean percentage errors of 1.57% for revolutions per minute measurements and 2.19% for torque measurements, demonstrating satisfactory accuracy for classroom use. The apparatus cost approximately USD 8, indicating strong potential as an affordable and accessible physics learning tool. The apparatus may support inquiry-based learning and help students connect theoretical rotational mechanics concepts with observable mechanical behaviour.

View source

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.