Influence of Polishing Treatment on the Topography of 3D‐Printed Provisional Resins: An In Vitro Study
Abstract
Although 3D‐printing has been increasingly integrated in the fabrication of provisional restorations, the evidence regarding the impact of different polishing regimens on their topographical features is unclear. This in vitro study assessed the outcomes of different polishing treatments on roughness measurements of 3D‐printed provisional resin materials compared to that of a conventional polymethyl methacrylate (PMMA). Disc‐shaped specimens were obtained from a conventional PMMA (GC Unifast III) and two commercially available 3D‐printed provisional resin materials (Asiga DentaTOOTH, NextDent C&B MFH). Specimens were allocated into four polishing treatments: unpolished (control), conventional pumice, Optiglaze, or chairside polishing. Surface roughness parameters (Ra, Rz) were quantified with a noncontact optical profilometer after polishing treatment. Qualitative surface analysis was obtained with representative 3D topographical color maps. Ra and Rz data were analyzed with a generalized linear model and Bonferroni‐corrected post hoc tests (α = 0.05). Lowest roughness was identified in Asiga DentaTOOTH and highest in conventional PMMA (p < 0.001). Optiglaze and conventional pumice yielded lower roughness measurements than chairside polishing (p < 0.001), and unpolished resins showed the most unfavorable roughness outcomes (p < 0.001). In conclusion, Optiglaze demonstrated promising potential in the improvement of 3D‐printed provisional resin restorations’ surface integrity, thus enhancing prostheses biocompatibility and long‐term survival.