Skip to content
Open access

A low-cost active noise control method integrating pre- generated steady-state anti-phase waveforms and band-limiting

2026 · Vol 3332 · 0 citations · 3 references
Physics

Abstract

Conventional real-time active noise control (ANC) systems are often technically demanding and costly because they rely on high-performance digital signal processors and adaptive algorithms. This study proposes a low-cost ANC method for steady-state noise sources. The operating noise is first recorded, and a corresponding anti-phase waveform is generated offline. A physical triggering mechanism is then used to synchronize the playback of the anti-phase waveform with the operation of the noise source. The results show that the proposed method is effective for specific steady-state noise sources. A standard-tone experiment confirmed the basic cancellation phenomenon and the feasibility of physical synchronization. In the scanner test, the average sound level decreased from 60.7 dB to 56.4 dB, corresponding to a reduction of 4.3 dB. For intuitive comparison only, this represents a 7.2% relative decrease on the measured dB scale, although dB values are logarithmic. The difference was statistically significant (p < 0.001), with a very large effect size (Cohen’s d ≈ 3.4). In the hair-dryer test, the results showed that noise reduction performance was jointly affected by frequency-band condition and synchronization error. Full-band noise was sensitive to synchronization mismatch, whereas low-pass filtering below 1 kHz improved robustness and maintained effective noise reduction under larger synchronization error.

Read PDF

We use cookies to run the site and, with your consent, for analytics and to show ads. See our Cookie Policy.