Passive mechanical interfaces offer a lightweight alternative to actuated manipulators for quadruped payload carrying, but their impedance directly couples the payload dynamics with the locomotion pattern. This paper analyzes how passive-arm stiffness-damping selection affects payload-carrying locomotion under different gait and payload conditions. We compare damped and underdamped passive-arm impedance configurations in simulation during flat-ground locomotion. For crawl gaits, where the support polygon remains well defined, the results show that underdamped impedance increases passive-joint oscillations and can reduce the ZMP margin with respect to the support polygon. Trot is retained as a dynamic excitation case for the passive arm, but it is not used for direct ZMP-margin stability comparison. The results are summarized in gait-payload-stiffness-damping maps, where ZMP-margin reduction is evaluated for crawl gaits and trot is retained only as a passive-arm excitation case.
Animals'body morphology shapes the gait patterns they can perform, where mechanical resonance reduces the need for active control. By tuning posture and muscle stiffness, they leverage their embodied intelligence to achieve effective gaits for different speeds. In contrast, most quadruped robots are not specifically de...
Annika Schmidt, Davide Calzolari, Arne Sachtler et al.· 0 citations
Humanoid robots could transport payloads substantially heavier than themselves by pulling passive wheeled vehicles instead of carrying the load. This capability, however, creates a coupled locomotion problem: the robot must maintain persistent upper-body contact while adapting to unknown, configuration-dependent forces...
Yang-Zhi Yang, Xian-Sheng Lin, Zhao-Ming Xie et al.· 0 citations
Low-friction surfaces challenge bipedal locomotion by limiting the contact forces available during stepping. Inspired by penguin waddling, we investigate how lateral torso motion and center of mass (COM) placement affect locomotion as surface friction changes. Using a five-actuator biped, we compare an upright-gait str...
Ben J. Gu, Naomi Oke, George Ortiz et al.· 0 citations
Snake robots operating in complex environments are susceptible to joint failures due to sustained high actuator loads, where large-angle joint locking severely distorts the gait shape and degrades motion performance. This paper presents an optimal path following control framework with gait generation for motion recover...
Spider robots are widely preferred due to their superior mobility enabled by multi-legged structures and articulated joints, which allow effective locomotion on uneven terrain and obstacle negotiation. However, the mechanical complexity of legged systems may lead to limited payload capacity, a high number of moving par...
Yusuf Bolat, Hüseyin Ömerbaşoğlu, Merdan Özkahraman et al.· Konya Journal of Engineering...· 0 citations
Quadruped robots are increasingly expected to carry objects while moving through human environments. But what happens when a person interacts directly with the payload rather than with the robot? If the payload is unrestrained, the robot must distinguish intentional external interactions from ordinary payload motion, w...
Shaunak A. Mehta, Mayank Mishra, Prajit KrisshnaKumar et al.· 0 citations
We use cookies to run the site and, with your consent, for analytics and to show ads.
See our Cookie Policy.