Shear Strengthening of Reinforced Concrete Beams Using Hybrid System of CFRP Composites Inside and over Groove
Abstract
Fiber-reinforced polymers (FRPs) are increasingly adopted in structural rehabilitation due to their high strength-to-weight ratio, corrosion resistance, and ease of installation, making them suitable for extending the service life of reinforced concrete (RC) infrastructure. Studies on shear strengthening with CFRP was early focused on externally boning (EB) showed premature delamination between fiber and concrete which limits the bonding strength. Hence, this study experimentally evaluates the shear strengthening behavior of RC beams retrofitted using inside-groove bonded CFRP and hybrid techniques. A total of seven beam specimens with identical geometry, internal reinforcement layout, and concrete strength were fabricated and tested under four-point bending to generate a well-defined shear-critical region. The experimental program focused on directly comparing bonding configurations while also examining the influence of groove depth (10 mm and 15 mm) and steel anchorage for concrete cover on structural response and failure mechanisms. The strengthened specimens achieved ultimate load increases ranging from approximately 10% to 23% relative to the control beam. Variation in groove depth within the investigated range did not significantly influence shear capacity, indicating that moderate groove penetration is sufficient to develop effective mechanical interlock. Steel anchors were introduced to restrain concrete cover separation and improve confinement of the bonded region and substantially increase peak load, it successfully mitigated premature cover delamination near stirrup locations and altered the governing failure mode.