Understanding the internal architecture of copolymer microgels is crucial for establishing how nanoscale polymer organization controls their stimuli-responsive behavior. Here we focus on thermoresponsive P(N-isopropylacrylamide-co-N-isopropyl-methacrylamide), P(NIPAM-co-NIPMAM), microgels with varying mole fraction of the components, synthesized via radical precipitation polymerization, and we demonstrate that changes in their volume phase transition and equilibrium swelling are governed by composition-dependent internal heterogeneity. Comparison between small-angle neutron scattering (SANS) with isotopic labeling and monomer-resolved simulations show a block-like monomer distribution of the two components. SANS analysis reveals a universal maximum in the polymer mesh correlation length near the transition, evidencing coexistence of collapsed NIPAM-rich and swollen domains. The correlation length increases with increasing NIPMAM content, with a maximum for 75 mol \% NIPMAM, implying sparse collapsed regions within the network and thus a large degree of heterogeneity induced by the presence of an increasingly large fraction of intercalated, non-collapsing PNIPMAM. The maximum heterogeneity correlates with the equilibrium swelling ratio, indicating that collapsed microgels retain a structural memory of the transition and present a less-compliant structure in response to temperature variations. Overall, these insights highlight a complex effect of the block-like monomer distribution on the responsive properties of copolymer microgels with different compositions, thus providing a design rule for tailoring responsive colloids for functional soft materials.
HYPOTHESIS
Poly(N-isopropylacrylamide) (PNIPAM) microgels are highly porous polymer networks whose mechanical properties are governed not only by environmental factors but also by their internal architecture. We hypothesize that the internal structure of microgels, together with interparticle interactions, synergistica...
Li Zhang, Wei Liu, To Ngai· Journal of Colloid and Inter...· 0 citations
Amphiphilic PEG multiblock copolymers can be readily synthesized by polycondensation reactions. Their multiblock structure leads to the formation of hydrogels consisting of highly interconnected micelles. Here, we investigate as model systems copolyesters consisting of alternating hydrophobic alkyldicarboxylic acids...
Tulika Sharma, R. Biehl, M. Dulle et al.· Macromolecules· 0 citations
A general design framework for fully bio-based block copolymers that integrates structural organization with macroscopic function remains largely unexplored, despite extensive study of amphiphilic systems. Herein, we address this challenge by designing fully bio-based diblock copolymers (i.e., Glc6/7-b-Sol) comprising...
W. Lang, Sho Fukushima, Minami Ebe et al.· ACS Applied Materials and In...· 0 citations
Thermoplastic elastomer gels constitute a valuable class of composition-tunable materials that are typically fabricated from styrenic ABA triblock copolymers (i) possessing a morphology with A-dispersions in a B-matrix and (ii) physically modified with a B-selective, low-volatility oil to controllably alter mechanica...
Kacie M. Wells, Alexey A. Gavrilov, Ivan Kuzmenko et al.· Macromolecules· 0 citations
Access to smaller phase domain dimensions requires reducing the degree of polymerization, which weakens segregation and increases the importance of strong segmental incompatibility; however, the same chemical contrast can impede direct sequential block copolymerization through differences in solvent affinity. Here, we...
Yi-Fan Tian, Xu-Le Yang, Wei-Jia Fan et al.· ACS Macro Letters· 0 citations
Cure-induced shrinkage in thermosetting polymers is generally assumed to reflect progressive densification during network formation. Here, we show that this assumption breaks down at gelation, which marks a transition in structural evolution. Using a model epoxy system, direct shrinkage measurements, wide-angle X-ray s...