Numerical Fatigue Analysis of CFRP Tension Elements in Cable Supported Bridges Under Multiaxial State of Stress
Due to their high strength-to-weight ratio and corrosion resistance, carbon fiber-reinforced polymers (CFRPs) are increasingly used as tension elements in bridge engineering. Their pronounced anisotropy, resulting from stiff carbon fibers and a weaker polymer matrix, is critical for fatigue behavior under multiaxial dynamic stress states, such as those occurring in stay cables over saddles of extradosed bridges or at clamps of suspension-bridge hangers. This multiaxial loading can cause progressive damage accumulation in the contact regions and lead to premature failure. To study this efficiently, an energy-based progressive damage analysis (PDA) model for CFRP tension elements under multiaxial fatigue loading was implemented as a vectorized user material in ABAQUS® 6.14 (VUMAT in FORTRAN) and validated against tension-tension fatigue tests on pin-loaded CFRP straps. The model was then applied to two representative bridge applications, viz. a clamped CFRP rod and a CFRP cable bent over a saddle, where parameters such as clamping pressure, maximum stress level, and friction coefficient were varied to quantify their influence on fatigue life and to assess suitability in line with fib recommendations. The results indicate that clamping pressures inducing transverse compressive stresses above roughly 85% of the CFRP’s transversal compressive strength significantly reduce fatigue life, whereas keeping the maximum fatigue stress below about 40% of the mean longitudinal tensile strength, the stress amplitude below 200 MPa, and the friction coefficient near 0.2 yields fatigue lives exceeding 2 × 106 load cycles, which is satisfactory under fib criteria.