Investigating the physical properties of modified pervious concrete containing different lightweight aggregates
Pervious concrete is an environmentally friendly paving concrete that has attracted significant attention due to its environmental advantages, particularly in mitigating the influences of urban heat and improving stormwater runoff. This study aims to investigate the influence of three types of lightweight coarse aggregates on the physical properties of pervious concrete mixtures. These types are pumice and two types of lightweight expanded clay aggregates (LECA): low density (LD) and high density (HD). Previous concrete mixtures were modified by styrene butadiene rubber (SBR) at 5% by cement mass and prepared. The physical properties of this type of concrete, including porosity, permeability, and hardened density, were investigated. The results indicated that replacing the normal coarse aggregate with a volumetric ratio of 10% lightweight coarse aggregates resulted in a significant increase in permeability and porosity while at the same time reducing density. The highest value of permeability was achieved by the mix containing 10% of LD without SBR, with an increment of 35.9%, compared to the control mix. The porosity was increased by 28.6% in the mix containing 10% of PA without SBR, compared to the control mix. On the other hand. Regardless of the type of lightweight coarse aggregate used, the addition of SBR to the lightweight aggregate mixtures significantly decreases the porosity and permeability while increasing density. Based on the findings of this study, it can be concluded that the type of aggregate chosen has a significant effect on the physical properties of pervious concrete